Immobilization of thiabendazole-specific monoclonal antibodies to silicon substrates via aqueous silanization

Monoclonal antibodies specific for thiabendazole were immobilized to silicon, silicon dioxide, stoichiometric silicon nitride, and silicon-rich silicon nitride surfaces. This work provides the foundation for the development of a homogeneous sensor system for rapid detection and quantification of thiabendazole residues in produce and animal tissue. Immobilization was performed via aqueous silanization of the substrate followed sequentially by treatment with glutaraldehyde and contact with antibody solution in the presence of detergent. Surfaces were challenged with thiabendazole-horseradish peroxidase conjugate in an ELISA format to estimate immobilized antibody load. A stable and reproducible surface loading of 2 x 10¹¹ antibodies/cm² was obtained only after surfaces received postimmobilization treatments to remove nonspecifically adsorbed antibody. No difference in surface loading was noted when using 30% hydrogen peroxide rather than nitric acid for silanol activation. Little difference was noted among the antibody loadings achieved on the various silicon substrates. Bound antigen-enzyme conjugate was eluted with 0.1N acetic acid and reproducible surface activity was measured for up to four consecutive antigen challenges. Immobilized antibody surfaces were stabilized with 2% sucrose, dehydrated at 37‡C and stored in vacuum or stored at 4‡C in phosphate buffered saline containing 0.01% sodium azide without significant loss of activity.     

过氧化物模拟酶在介体型生物传感器方面应用初探

meso-四(4-磺基苯)卟啉锰(Ⅲ)作为过氧化物模拟酶可催化H_2O_2与K_4Fe(CN)_6反应。电流响应与H_2O_2浓度在3.0×10~(-4)～1.0×10~(-3)mol/L范围内呈线性关系。重现性和回收率良好。抗坏血酸和DL-半胱氨酸干扰严重。     

二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

裸玻碳电极伏安测定甲氰咪胍

提出了裸ＧＣＥ不需任何处理测定甲氰咪胍的方法，浓度在３×１０＾－７－６×１０＾－５ｇ／ｍＬ，范围内与峰电流呈线性关系，ＲＳＤ为２．２％，回收率为９６％－１０２％。该方法操作简便快速，大多数金属离子和多种有机生化物质不干扰测定，方法用于片剂和加标尿样中甲氰咪胍的测定与药典方法对照，获得满意结果，并对电极反应进行了初步探讨。     

二氧化碳氧化剂在烷烃催化转化反应中的应用研究进展

本文综述了近年来国内外有关利用二氧化碳作为氧化剂在烷烃催化转化反应中的研究状况。担载型的金属氧化物催化剂具有较好的催化活性。催化剂表面碱性位的存在可稳定活性中心并且有利于CO2的活化，CO2的作用是与烷烃脱氢产物H2和生成的表面积炭反应，从而提高反应活性及催化剂的稳定性。     

大气气溶胶中有机碳和元素碳监测方法的进展

本文主要介绍和评述了近10年来大气气溶胶中的有机碳和元素碳的采样和分析技术的进展,引用参考文献41篇。     

纳米金修饰玻碳电极在抗坏血酸共存下选择性测定去甲肾上腺素

利用电沉积的方法制得纳米金修饰玻碳电极 ,该修饰电极对去甲肾上腺素 (NE)氧化反应有催化作用。去甲肾上腺素在纳米金修饰玻碳电极上有很强的吸附作用。研究了磷酸缓冲溶液的pH值和浓度对NE的电化学行为的影响。从去甲肾上腺素和抗坏血酸在纳米金修饰电极的循环伏安图上可观察到两个明显分开的氧化峰 ,峰电位差达到 1 3 1mV ,因此 ,可利用该修饰电极在抗坏血酸存在下选择性测定去甲肾上腺素 ,线性范围为 1× 1 0 - 4 ～5× 1 0 - 6 mol L。     

Sm修饰的Ni-MgO催化剂制备碳纳米管的研究

Carbon nanotubes (CNTs) have been synthesized over Ni-MgO and Ni-Sm-MgO catalysts by decomposition of CH₄ at 650 ℃. The addition of Sm into Ni-MgO catalyst not only promotes the catalytic activity and lifetime of the catalyst, but also improves the graphitization and heat stability of carbon nanotubes. The yield of CNTs obtained over the Ni-10Sm-MgO catalyst reaches 33 g C·(g Ni)^-1, being more than 5 times higher than that of the Ni-MgO catalyst. XRD and TPR results of the catalysts indicate that there is a remarkable interaction of Ni with Sm species, which facilitates the reduction of nickel and restrains the Ni particles from agglomerating.     

Temperature Development of Homo- and Hetero-Clustering in Saturated Vapors

Computational findings of temperature increase of clustering degree in saturated vapors are analyzed. A thermodynamic proof is presented and a simple criterion derived. Illustrations are based on saturated steam, magnesium and carbon vapor. The results are applicable to synthesis of fullerenes, metallofullerenes, and heterofullerenes, chemical vapor deposition technique, or atmospheric chemistry.